收藏本站
LT3498
OPERATION — LED DRIVER
The LED portion of the LT3498 uses a constant-frequency,
current mode control scheme to provide excellent line
and load regulation. Operation can be best understood
by referring to the Block Diagram.
At power-up, the capacitor at the CAP1 pin is charged up
to V IN (input supply voltage) through the inductor and the
internal Schottky diode. If CTRL1 is pulled higher than
125mV, the bandgap reference, the start-up bias and the
oscillator are turned on. At the start of each oscillator cycle,
the power switch Q1 is turned on. A voltage proportional
to the switch current is added to a stabilizing ramp and the
resulting sum is fed into the positive terminal of the PWM
comparator, A2. When this voltage exceeds the level at the
negative input of A2, the PWM logic turns off the power
switch. The level at the negative input of A2 is set by the
error ampli?er A1, and is simply an ampli?ed version of
the difference between the V CAP1 and V LED1 voltage and
the bandgap reference. In this manner the error ampli?er,
A1, sets the correct peak current level in inductor L1 to
keep the output in regulation. The CTRL1 pin is used to
adjust the LED current. The LED Driver is shutdown when
reduced, the device will begin skipping pulses. This will
result in some low frequency ripple, although the average
LED current remains regulated down to zero. The photo in
Figure 1 details circuit operation driving four white LEDs
at 2mA load. Peak inductor current is less than 60mA and
the regulator operates in discontinuous mode, meaning
the inductor current reaches zero during the discharge
phase. After the inductor current reaches zero, the SW1
pin exhibits ringing due to the LC tank circuit formed
by the inductor in combination with the switch and the
diode capacitance. This ringing is not harmful; far less
spectral energy is contained in the ringing than in the
switch transitions.
I L
50mA/DIV
V SW
10V/DIV
CTRL1 is pulled lower than 75mV.
V IN = 4.2V
200ns/DIV
3498 F01
I LED = 2mA
Minimum Output Current
The LED Driver of the LT3498 can drive a 4-LED string at
2mA LED current, without pulse-skipping, using the same
4 LEDs
Figure 1. Switching Waveforms with
Four White LEDs at 2mA Load
external components shown in the application circuit on
the front page of this data sheet. As current is further
3498fa
8
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LT3517HUF#PBF IC LED DRIVER AUTOMOTIVE 16-QFN
LT3519EMS-2#PBF IC LED DRVR HP CONST CURR 16MSOP
LT3590ESC8#TRMPBF IC LED DRVR WHITE BCKLGT SC-70-8
LT3591EDDB#TRMPBF IC LED DRIVER WHITE BCKLGT 8-DFN
LT3593ES6#TRMPBF IC LED DRIVR WHITE BCKLGT TSOT-6
LT3595AEUHH#TRPBF IC LED DRIVR WHITE BCKLGT 56-QFN
LT3595EUHH#TRPBF IC LED DRIVR WHITE BCKLGT 56-QFN
LT3596EUHG#PBF IC LED DVR 300MA ADJ 52-VQFN
相关代理商/技术参数
LT34-SC 制造商:THOMAS & BETTS 功能描述:
LT3500 制造商:World Products 功能描述:
LT3500EDD#PBF 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500EDD#TRPBF 功能描述:IC REG DL BUCK/LINEAR 12-DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500EDD-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500EDD-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:Monolithic 2A Step-Down Regulator Plus Linear Regulator/Controller
LT3500EMSE#PBF 功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LT3500EMSE#TRPBF 功能描述:IC REG DL BUCK/LINEAR 16-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 + 切换式 系列:- 标准包装:2,500 系列:- 拓扑:降压（降压）同步（3），线性（LDO）（2） 功能:任何功能 输出数:5 频率 - 开关:300kHz 电压/电流 - 输出 1:控制器 电压/电流 - 输出 2:控制器 电压/电流 - 输出 3:控制器 带 LED 驱动器:无 带监控器:无 带序列发生器:是 电源电压:5.6 V ~ 24 V 工作温度:-40°C ~ 85°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*